Note: Again, please follow the manual on the right way to prime your filter. After I put everything into place and got the hoses where I wanted them, the next step is to prime the filter. For this particular model, it has an inlet hose and an outlet hose (that has a spray bar). These are very easy to setup and get going. Water Filter - I am using an Eheim cannister filter. This will help provide oxygen to the fish that will eventually be calling this place home. I ran the tubes to 2 different ends of the tank and used rocks/wood to hold it down into place. I am using routines on Google Home to control thisĪir Pump - I used an air pump that has dual outlets. This will be setup on a 12 hour cycle (12 hours on / 12 hours off). Light - I am using a LED light that is full spectrum. Set it to 72F and ensure that the water level is in between the 2 operating lines Water Heater - For this, I placed it in the middle of the tank. The power bar sits behind the book shelf with all the power from the heater, pump, air pump, and lights connect to it. This will also allow me to use Google to control everything. This allows me to be able to control everything in the aquarium even when I am not at home. I used a Smart WiFi power bar to connect everything to. Warning: Please refer to manufacturer's manual when setting up equipment to ensure it is done properly. After I was satisfied with the placement of the stand, I began to place all the equipment.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |